Maurizio Marini <maumar@xxxxxxxxxxxxxx> escribiÃ:
On Sat, 6 Nov 2010 10:25:43 +0100
Kinkie <gkinkie@xxxxxxxxx> wrote:
On Fri, Nov 5, 2010 at 3:26 PM, Maurizio Marini
<maumar@xxxxxxxxxxxxxx> wrote:
> Hi there
[...]
> samba is pdc with ldap backend
> Now i should authenticate squid with samba on the same server. I
cannot use
> winbind (winbind should be used on samba domain member, isn'it), so
> following link:
> http://wiki.squid-cache.org/ConfigExamples/Authenticate/NtlmCentOS5
> is not useful, or, better: i tried to configure winbind using this wiki
> with no success.
A domain controller is also a domain member ; the same configuration
should apply.
You may want to detail what you did, and what error messages you
got - if any.
--
  /kinkie
i stil get this error ;(
wbinfo -a user%password
plaintext password authentication failed
Could not authenticate user user%password with plaintext password
challenge/response password authentication failed
error code was NT_STATUS_CANT_ACCESS_DOMAIN_INFO (0xc00000da)
error messsage was: NT_STATUS_CANT_ACCESS_DOMAIN_INFO
Could not authenticate user user with challenge/response
wbinfo -t
checking the trust secret via RPC calls failed
error code was NT_STATUS_CANT_ACCESS_DOMAIN_INFO (0xc00000da)
Could not check secret
should i join domain when client and server are on the same host?
maybe it is better to post on samba lists, too
thnx
maurizio
You need two smb.conf. One for the domain controller and another for
the winbind.
I have a smb.conf and a winbind.conf, and the winbindd uses the winbind.conf.
Yes, you have to joing the winbind to the domain, with:
net rpc join -s /etc/samba/winbind.conf -U username
Hope this helps.
Bye.
