Hi! THANK YOU! I Think my problem is solved. It wasn't in my config. I've just added this line, and started to see UDP packets between the two nodes. THANKS AGAIN! Do you have anything else You recomment to put in when you have 2 nodes ? Tibby -----Original Message----- From: Matus UHLAR - fantomas [mailto:uhlar@xxxxxxxxxxx] Sent: Thursday, September 16, 2010 1:46 PM To: squid-users@xxxxxxxxxxxxxxx Subject: Re: RE: Two squid servers to talk to each other before the internet On 10.09.10 10:27, Tóth Tibor Péter wrote: > That's impossible. > Both nodes are in the same subnet. > 192.168.50.56, and 192.168.50.57 > They dont even go trough the gateway to access each other. > If I put back the "always_direct allow all" in the config, everything works fine again, and I can see my requests in the log. > > Any other idea? > Do you think this might be a problem with squid 3.0, and should I try 3.1.8? while it's wotsh trying 3.1.8, i doubt your problem will be due to 3.0. Do you have icap_port enabled? -- Matus UHLAR - fantomas, uhlar@xxxxxxxxxxx ; http://www.fantomas.sk/ Warning: I wish NOT to receive e-mail advertising to this address. Varovanie: na tuto adresu chcem NEDOSTAVAT akukolvek reklamnu postu. Remember half the people you know are below average.
