>-----Original Message----- >From: Amos Jeffries [mailto:squid3@xxxxxxxxxxxxx] >Sent: Wednesday, April 07, 2010 10:56 PM > >Mellem, Dan wrote: >> Hi, >> >> Thanks for your response. Please see below. >> >>> From: Amos Jeffries [mailto:squid3@xxxxxxxxxxxxx] >>> Sent: Wednesday, April 07, 2010 7:33 PM >>> On Wed, 07 Apr 2010 19:12:53 -0700, "Mellem, Dan" >> >> I do a: >> tail -f access.log | fgrep '<my IP address>' >> >> and only get responses for allowed traffic. I also don't >have any 407s >> at all in the log. >> You said the logging is on by default. Is there a way to it off or to >> turn on debugging that would show where it's getting dropped? >> [...] >> >> If I type the wrong password, I get re-prompted for authentication >> again. I get the normal: >> >> GET >> 407 Proxy Authentication Required >> GET w/Proxy-Authorization: Basic (wrong password) >> 407 Proxy Authentication Required >> GET w/Proxy-Authorization: Basic (right password) >> 200 OK >> > >Okay thats good then. Those 407 _should_ be in the access.log. > >If you grep the log for " 407 " (note the spaces) or the date >and minute >when the tests were done instead of your IP you may see them. >It should >have been visible with an IP though. > >The only ways to get things not logged is to add ACL after the >specific >access_log line, or to add "log_access" lines preventing things being >logged globally. > >Amos Hi, Amos, I searched the logs for 407 results and didn't find any at all (I searched for '" 407 ' since I was getting some file sizes of 407 bytes [the pattern '" 404 ' did find matches]). The access log is the default, and has no ACL associated. access_log /usr/local/squid/var/logs/access.log There are no log_access entries in the configuration, either. Update: OK, I found the problem. The accessLogLog() function in access_log.c had been altered to only log successful requests. It was left over from an old Smartfilter installation. I commented out the lines and I'm now getting the 407 entries in the log. Thanks for your help. -Dan
