Amos, Thanks for your response. I have the following already installed: gssapi related: 'cyrus-sasl-gssapi' 'cyrus-sasl-gssapi-32bit' 'libgssglue1' 'librpcsecgss' krb related: 'krb5' 'krb5-32bit' 'krb5-client' I also looked through the config.log where Markus indicated and found the following errors in relation to gssapi: configure:4188: checking gssapi.h usability configure:4205: gcc -c -g -O2 conftest.c >&5 conftest.c:54:20: error: gssapi.h: No such file or directory configure:4212: $? = 1 configure: failed program was: | /* confdefs.h. */ configure:4230: checking gssapi.h presence configure:4245: gcc -E conftest.c conftest.c:21:20: error: gssapi.h: No such file or directory configure:4252: $? = 1 configure: failed program was: | /* confdefs.h. */ configure:4299: checking for gssapi.h configure:4308: result: no configure:4188: checking gssapi/gssapi.h usability configure:4205: gcc -c -g -O2 conftest.c >&5 conftest.c:54:27: error: gssapi/gssapi.h: No such file or directory configure:4212: $? = 1 configure: failed program was: | /* confdefs.h. */ Any other ideas? Thanks! -----Original Message----- From: Amos Jeffries [mailto:squid3@xxxxxxxxxxxxx] Sent: Friday, August 14, 2009 11:47 PM To: Daniel Cc: 'Markus Moeller'; squid-users@xxxxxxxxxxxxxxx Subject: Re: Re: Kerberos Authentication - Squid 3.1.0.13 Daniel wrote: > Markus, > > First, please correct me if I'm wrong but I looked for 'gssapi.h' in > config.log and I'm assuming that config.log contains all the log information > from doing a /configure? Assuming that I am correct, I couldn't find > 'gssapi' anywhere inside the log file so I'm not sure if that's a good thing > or a bad thing. bad. config.log is supposed to contain a full dump of the output of ./configure when it was last run. > > I went ahead and dumped the output of the ./configure to a file and these > are the only lines that I could find for gssapi.h: > > checking gssapi.h usability... no > checking gssapi.h presence... no > checking for gssapi.h... no > checking gssapi/gssapi.h usability... no > checking gssapi/gssapi.h presence... no > checking for gssapi/gssapi.h... no > > If there's anything else that I could try, I'd greatly appreciate it. > Thanks! You could try installing the gssapi development libraries on your build machine. (sometimes called libkrb or libkrb5). Then re-running ./configure Amos -- Please be using Current Stable Squid 2.7.STABLE6 or 3.0.STABLE18 Current Beta Squid 3.1.0.13
