Henrik,
Thanks for your prompting reply.
I had configured the WCCP rules on the Ethernet 0 interface(Clients
connected interface). Eth 1 - Squid server, Serial Int - internet.
ip wccp 80 redirect in
ip wccp 90 redirect out
WCCP status in the router.
Cisco-2851-IFT#sh ip wccp 80 detail
WCCP Client information:
WCCP Client ID: xx.xx.xx.xx
Protocol Version: 2.0
State: Usable
Initial Hash Info: 00000000000000000000000000000000
00000000000000000000000000000000
Assigned Hash Info: FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
Hash Allotment: 256 (100.00%)
Packets s/w Redirected: 5
Connect Time: 00:04:31
Bypassed Packets
Process: 0
Fast: 0
CEF: 0
Errors: 0
Cisco-2851-IFT#sh ip wccp 90 detail
WCCP Client information:
WCCP Client ID: xx.xx.xx.xx
Protocol Version: 2.0
State: Usable
Initial Hash Info: 00000000000000000000000000000000
00000000000000000000000000000000
Assigned Hash Info: FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
Hash Allotment: 256 (100.00%)
Packets s/w Redirected: 0
Connect Time: 00:05:11
Bypassed Packets
Process: 0
Fast: 0
CEF: 0
Errors: 0
Please give some ideas for troubleshooting this..
Thanks
Vivek N.
-----Original Message-----
From: Henrik Nordstrom <henrik@xxxxxxxxxxxxxxxxxxx>
To: Vivek <viveksnv@xxxxxx>
Cc: squid-users@xxxxxxxxxxxxxxx
Sent: Wed, 18 Feb 2009 5:10 pm
Subject: Re: Re: Need your help : Tproxy + WCCP
ons 2009-02-18 klockan 06:31 -0500 skrev Vivek:
wccp2_router xx.xx.xx.xx
wccp_version 4
Why? This is related to WCCP(v1) and 4 is the default. No need to
specify. In fact we should probably remove this directive even as it's
not of any much practical use today, those with such old IOS versions
better upgrade anyway..
wccp2_forwarding_method 1
wccp2_return_method 1
wccp2_assignment_method 1
wccp2_service dynamic 80
wccp2_service_info 80 protocol=tcp flags=src_ip_hash priority=240
ports=80
Ok.
wccp2_service dynamic 90
wccp2_service_info 90 protocol=tcp flags=dst_ip_hash,ports_source
priority=240 ports=80
No obvious errors there.
and service 80 and 90 are enabled in the router. But only 80 service
is
working( Packets redirected), 90 service is not working.
I would triple-check that the router config is correct.
- Service configured
- The router view of the wccp state.
- That the wccp service is attached to the right interface of the
router
Regards
Henrik
________________________________________________________________________
You are invited to Get a Free AOL Email ID. - http://webmail.aol.in