Dear list, I'm trying to get squid running with two cisco-routers, but after a lot of trial, I'm on the brink of nonsense... The two cisco-routers are a 2600 and 3800, both in the same sub-net, connected to a squid-proxy (2.6) over wccp2 and gre. If I try to use the proxy from either cisco-router, there is no problem. But if I try to use the proxy from both routers, the proxy is visible to the routers, but "not usable". I change from one configuration to the other by using one or two "wccp2_router"-lines. Debugging the issue with debug_options 80,9 shows that only one of the two routers is replying, but not the other one, and that the replies are of a different length (only 136 bytes) than when it works with only one router (180 bytes). Is there anything I can do to test this issue further? I would really like to get this configuration going, but I'm really lost for the moment. Could it be something with the GRE-tunnel? One router works whether I set the tunnel up or not, and both tunnel work neither with the GRE-tunnel, neither without. I hope I make sense ;) Linus
