Hello everyone,
I wanted to run transparent proxy on a RHEL 4.0 machine (using rpm based SQUID provided with RHEL4.0). All configs were done. But I couldn't get the transparent benefit of SQUID, i.e. I had to enter proxy server's IP and port (3128) in each client's LAN settings. If I don't do that, there is no entry in var/log/squid/access.log. I have also entered iptables entry as : iptables -t nat -A PREROUTING -i eht1 -p tcp --dport 80 -j REDIRECT --to-port 3128 - but all in vain. I also replaced the eth1 in iptables to eth0; which is directly connected to the DSL router; but that didn't work either.
Settings/Configurations I did are as follows:
httpd_port 3128
acl allowedips src 192.168.1.0/24
http_access allow allowedips
http_access allow localhost
http_access deny all
visible_hostname server1
Below are the settings I did FOR TRANSPARENT PROXY:
httpd_accel_host virtual
httpd_accel_port 80
httpd_accel_with_proxy on
httpd_accel_uses_host_header on
Can someone plz tell me what is the problem. Thx in advance.
Looking forward to your reply/suggestion.
Regards,
Javed
____________________________________________________________________________________Ready for the edge of your seat?
Check out tonight's top picks on Yahoo! TV.
http://tv.yahoo.com/
