Hi... I did not find pharse "ARP enabled" or something like that.. could you please more detail what words should I check on config.log? TIA Regards Winanjaya ----- Original Message ----- From: "Matus UHLAR - fantomas" <uhlar@xxxxxxxxxxx> To: <squid-users@xxxxxxxxxxxxxxx> Sent: Tuesday, October 04, 2005 2:44 PM Subject: Re: aclParseAclLine: Invalid ACL type 'arp' > On 04.10 14:07, Winanjaya - PBXSoftwares wrote: > > After recompile squid with > > > > ./configure --enable-arp-acl ... > > make clean > > make > > > > then I apply my squid.conf > > to the new squid (sure)? > > > but I got below messages: > > > > aclParseAclLine: Invalid ACL type 'arp' > > squid.conf line 1812: http_access allow ACLARP > > aclParseAccessLine: ACL name 'ACLARP' not found. > > squid.conf line 1812: http_access allow ACLARP > > aclParseAccessLine: Access line contains no ACL's, skipping > > > > Did I miss something? > > check config.log if ARP acl's were enabled. Maybe you need some additional > header files to compile squid with ARP acl's > > -- > Matus UHLAR - fantomas, uhlar@xxxxxxxxxxx ; http://www.fantomas.sk/ > Warning: I wish NOT to receive e-mail advertising to this address. > Varovanie: na tuto adresu chcem NEDOSTAVAT akukolvek reklamnu postu. > Windows found: (R)emove, (E)rase, (D)elete >
