Mikael I'm getting tired of continuing to add the proper mailing list CC: for your sparc bug reports. Please make sure to add sparclinux@xxxxxxxxxxxxxxx to your reports in the future. Thanks. > Booting 2.6.35-rc1 on a Sun Blade 2500 Red with builtin tg3 I get: > > tg3.c:v3.110 (April 9, 2010) > PCI: Enabling device: (0000:00:03.0), cmd 2 > ... > tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update. > tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update. > tg3 0000:00:03.0: vpd r/w failed. This is likely a firmware bug on this device. Contact the card vendor for a firmware update. > tg3 0000:00:03.0: eth0: Tigon3 [partno(none) rev 1002] (PCI:66MHz:64-bit) MAC address ... > tg3 0000:00:03.0: eth0: attached PHY is 5703 (10/100/1000Base-T Ethernet) (WireSpeed[1]) > tg3 0000:00:03.0: eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1] > tg3 0000:00:03.0: eth0: dma_rwctrl[763f0000] dma_mask[32-bit] > ... > tg3 0000:00:03.0: eth0: No firmware running > tg3 0000:00:03.0: eth0: Link is up at 100 Mbps, full duplex > tg3 0000:00:03.0: eth0: Flow control is on for TX and on for RX > > The three 'vpd r/w failed' messages are new and did not occur with 2.6.34 > or earlier kernels. > > /Mikael -- To unsubscribe from this list: send the line "unsubscribe sparclinux" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
