On Thu, Jun 9, 2016 at 1:38 PM, Deepa Dinamani <deepa.kernel@xxxxxxxxx> wrote:
>
> 1. There are a few link, rename functions which assign times like this:
>
> - inode->i_ctime = dir->i_ctime = dir->i_mtime = CURRENT_TIME;
> + inode->i_ctime = dir->i_ctime = dir->i_mtime =
> current_fs_time(dir->i_sb);
So I think you should just pass one any of the two inodes and just add
a comment.
Then, if we hit a filesystem that actually wants to have different
granularity for different inodes, we'll split it up, but even then
we'd be better off than with the superblock, since then we *could*
easily split this one case up into "get directory time" and "get inode
time".
> 2. Also, this means that we will make it an absolute policy that any filesystem
> timestamp that is not directly connected to an inode would have to use
> ktime_get_* apis.
The thing is, those kinds of things are all going to be inside the
filesystem itself.
At that point, the *filesystem* already knows what the timekeeping
rules for that filesystem is.
I think we should strive to design the "current_fs_time()" not for
internal filesystem use, but for actual generic use where we *don't*
know a priori what the rules are, and we have to go to this helper
function to figure it out.
Inside a filesystem, why *shouldn't* the low-level filesystem already
use the normal "get time" functions?
See what I'm saying? The primary value-add to "current_fs_time()" is
for layers like the VFS and security layer that don't know what the
filesystem itself does.
At the low-level filesystem layer, you may just know that "ok, I only
have 32-bit timestamps anyway, so I should just use a 32-bit time
function".
> 3. Even if the filesystem inode has extra timestamps and these are not
> part of vfs inode, we still use
> vfs inode to get the timestamps from current_fs_time(): Eg: ext4 create time
But those already have an inode.
In fact, ext4 is a particularly bad example, since it uses the
ext4_current_time() function to get the time. And that one gets an
inode pointer.
So at least one filesystem that already does this, already uses a
inode-based model.
Everything I see just says "times are about inodes". Anything else
almost has to be filesystem-internal anyway, since the only thing that
is ever visible outside the filesystem (time-wise) is the inode.
And as mentioned, once it's internal to the low-level filesystem, it's
not obvious at all that you'd have to use "currenf_fs_time()" anyway.
The internal filesystem code might very well decide to use other
timekeeping functions.
Linus
_______________________________________________
Selinux mailing list
Selinux@xxxxxxxxxxxxx
To unsubscribe, send email to Selinux-leave@xxxxxxxxxxxxx.
To get help, send an email containing "help" to Selinux-request@xxxxxxxxxxxxx.
