On Sat, 2003-08-16 at 05:34, Irv Cobb wrote:
> Just installed a new mainboard (PCCHIPS M810D) and did a fresh install of RH 9. At boot
> time I'm getting this:
>
> ----------------------------------------------------------------------------------------------------
>
> VFS: Mounted root (ext2 filesystem).
> Journalled Block Device driver loaded
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hdb: DMA disabled
> ide0: reset: success
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> ide0: reset: success
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> end_request: I/O error, dev 03:07 (hda), sector 4120
> kjournald starting. Commit interval 5 seconds
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> hda: dma_intr: status=0x51 { DriveReady SeekComplete Error }
> hda: dma_intr: error=0x84 { DriveStatusError BadCRC }
> ide0: reset: success
> EXT3-fs: mounted filesystem with ordered data mode.
> Freeing unused kernel memory: 128k freed
>
> --------------------------------------------------------------------------------------------
>
> The system then boots normally and seems to be stable and to run fine.
> What does all this mean? Is my data secure? Do I need to worry about it?
> Is there a fix?
-----
Check your hard drive cable connections to the motherboard and to the
hard drive.
Craig
--
Shrike-list mailing list
Shrike-list@xxxxxxxxxx
https://www.redhat.com/mailman/listinfo/shrike-list
