dsavage@xxxxxxxxxxx wrote:
On Wed, April 30, 2003 12:42, Oliver Schulze wrote:Its a SCSI disc, a Maxtor 10KIII. I see like 3 message in a row and then stops.
Hi, I'm running RH9 and noted this error en /var/log/messages:
"kernel: (scsi:A:6:0): parity error detected in Status phase. SEQADDR(0x7f) SCSIRATE(0x88)"
The SEQADDR change with this values: 0x9e, 0xa5, 0x82
The Adaptec card is: AHA-2940 U/UW/D AIC-7881U
The mobo is an ASUS P4S-533-MX running a Pentium 4 1700Mhz
Anyone has seen this message? I want to know if this is a critical data
loss error.
I also have seen this error during install of RH8.0 in the same machine.
Oliver,
I'll assume your cabling and terminations are OK.
Is this a one-time error, or at least an infrequent one? If so, it's
probably a random data error on Channel A, SCSI ID=6, LUN=0 (a tape
drive?). I wouldn't worry about it unless you start seeing multiple
errors. In that case you could have a cable problem or a device that needs
maintenance.
Every few minutes I receive again those message.
You could check the parity configurations of your Adaptec card and deviceOk, will check the hard disk for jumpers and in the manual.
#6 to make sure they're the same. If you disable parity on device #6
(usually via a jumper), parity will still be generated but any errors will
not be transmitted down the cable to the host adapter.
Will keep informed.
Many thanks Oliver
--Doc Savage Fairview Heights, IL
-- Oliver Schulze L. <oliver@xxxxxxxxxxxxx>
