Hi ! Leonard Thanks for replying so soon Running mii-tool -v eth0: 10 Mbit, half duplex, no link product info: vendor 00:00:00, model 0 rev 0 basic mode: 10 Mbit, half duplex basic status: no link capabilities: advertising: The output with regards to product info and basic status (nic is up) informs me that the current nic drivers does not use mii feature. Attempting to reconfigure the output is the same as the above. The card drivers installed by default on installation of linux is 3com 3c590/3c595/3c90x/3cx980. Is this acceptable driver ? An ideas on the steps that I can take. Many Thanks Vikash -----Original Message----- From: Leonard Miller [mailto:Leonard_Miller@udlp.com] Sent: 26 February 2003 06:16 To: Vikash@kentron.co.za; psyche-list@redhat.com Subject: Re: setting network interface card to 100Mb/s half duplex man mii-tool >>> Vikash@kentron.co.za 02/26/03 11:07AM >>> Hi ! All I need some assistance in anchoring a NIC to 100Mb/s half duplex. Thanking you in advance Vikash ******************************************************************************************************* Disclaimer: The information contained in this communication is confidential and may be legally privileged. It is intended solely for the use of the individual or entity to whom it is addressed and others authorised to receive it. Any review, retransmission, dissemination, copying, disclosure or other use of, or taking of any action in reliance upon, this information by person or entities other then the intended recipient is prohibited. If you have received this message in error, please notify the sender immediately by e-mail, facsimile or telephone and return and/or destroy the original message and all copies from any computer. Kentron, a division of Denel (Pty) Ltd, exercises no editorial control over e-mail messages originating in the organisation and does not accept any responsibility for either the contents of the message or any copyright laws that may have been violated by the person sending this message. Kentron is neither liable for the proper and complete transmission of the information contained in this communication nor any delay in its receipt. This message should not be copied or used for any purpose other than intended, nor should it be disclosed to any other person. ******************************************************************************************************* -- Psyche-list mailing list Psyche-list@redhat.com https://listman.redhat.com/mailman/listinfo/psyche-list
