Hi, Thanks for your answer, I have done what you told and I get the host, but I get an error in the /var/log/vdsm/vdsm.log MainThread::ERROR::2010-10-06 19:20:19,630::ksm::28::vds::failed to find kksmd thread and the host is in status "Non Responsive" What I have to do now to get the node up??? Thanks again, ESG 2010/10/6 Vincent Van der Kussen <Vincent.VanderKussen@xxxxxxxxxxxxxxx> > Hi, > > Just go to the RHEV Manager and add the host. It needs to be subscribed to > the right channels. > Once added in the RHEV Manager, the host will be automatically installed as > a hypervisor host. > > Regards, > Vincent > > > Vincent Van der Kussen > System Engineer > direct: +32 3 369 01 93 > Vincent.VanderKussen@xxxxxxxxxxxxxxx > > BTR Services > Groene Hofstraat 31 > 2850 Boom > Belgium > www.btr-services.be > tel: +32 3 450 89 80 > fax: +32 3 450 89 89 > > > > - DISCLAIMER - > This message contains confidential information and is intended only for > redhat-list@xxxxxxxxxxx If you are not redhat-list@xxxxxxxxxx, you should > not disseminate, distribute or copy this e-mail. Please notify > Vincent.VanderKussen@xxxxxxxxxxxxxxx immediately by e-mail if you have > received this e-mail by mistake and delete this e-mail from your system. > E-mail transmission cannot be guaranteed to be secure or error-free as > information could be intercepted, corrupted, lost, destroyed, arrive late or > incomplete, or contain viruses. Vincent Van der Kussen therefore does not > accept liability for any errors or omissions in the contents of this > message, which arise as a result of e-mail transmission. If verification is > required please request a hard-copy version. > -------------------------------------------------------------------------- > > ________________________________________ > > From: redhat-list-bounces@xxxxxxxxxx [redhat-list-bounces@xxxxxxxxxx] On > Behalf Of ESGLinux [esggrupos@xxxxxxxxx] > Sent: Wednesday, October 06, 2010 5:53 PM > To: General Red Hat Linux discussion list > Subject: how to setup a RHEV hypervisor using RHEL > > Hi all, > > I´m trying to use a RHEL 5.5 as hypervisor but I can´t get it,. > > I have followed the > doc > Red_Hat_Enterprise_Virtualization_for_Servers-2.2-Installation_Guide-en-US.pdf > but I can´t get the server in the RHEV Manager > > When I install a standalone hypervisor automatically I get the host > registered in the RHEV Manager, but with RHEL I don´t get it and I don´t > know how to register it. > > Anyone know how to do it? > > Thanks in advance > > ESG > -- > redhat-list mailing list > unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe > https://www.redhat.com/mailman/listinfo/redhat-list > > > -- > redhat-list mailing list > unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe > https://www.redhat.com/mailman/listinfo/redhat-list > -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
