On Fri, Apr 17, 2009 at 10:06:49AM -0700, Ryan Golhar wrote: > How do I determine the device mapping of a SCSI drive to the SCSI host, > bus, lun? And How to I remove the mapping to delete the SCSI drive? > > I have a fibre-connected SAN. I've created a few drives on the SAN and > mapped it to my linux host. The linux host sees the drives just fine. > I remove the drives from linux, and left them as uninitialize disks. > Whenever I run "fdisk -l", I get output: > > [root@cicweb1 tmp]# /sbin/fdisk -l > > Disk /dev/sda: 440.0 GB, 440076861440 bytes > 255 heads, 63 sectors/track, 53502 cylinders > Units = cylinders of 16065 * 512 = 8225280 bytes > > Device Boot Start End Blocks Id System > /dev/sda1 * 1 13 104391 83 Linux > /dev/sda2 14 53502 429650392+ 8e Linux LVM > This might help: http://kbase.redhat.com/faq/docs/DOC-3942 I typically use /proc/scsi/scsi or lsscsi to list the devices and figure out which ones I want to remove, then use the appropriate command to remove the device. > I also get in /var/log/messages that drives that I since removed from > the SAN. How to I remove these (/dev/sdb and /dev/sdc) in linux? <snip> I wonder if you have multipathing set up? The failover path often will show up as an invalid or unavailable drive. This usually can be fixed by setting the correct multipath device settings in your /etc/multipath.conf config file. Ray -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
