So I have the source kernel and link and I have to do the following : But what's the values for <Module_name>, <module_version> and <Kernel_arch> that I should use (in the instructions below) : Building and installing kernel module in general case >If the setup cannot compile the necessary kernel module you >will have to do it manually. Please install kernel sources, >apropriate config file and all required for kernel build >packages (like gcc, glibc-devel, etc). You will be prompted >about necessary packages while kernel sources install. >Most often the snapapi kernel module should be built and >installed by "dkms" command. It may be done by the following >commands: ># dkms build -m <MODULE_NAME> -v <MODULE_VERSION> \ > --config <CONFIG_FILE> --arch <KERNEL_ARCH> \ > --kernelsourcedir <PATH_TO_KERNEL_SOURCES> ># dkms install -m <MODULE_NAME> -v <MODULE_VERSION> \ > --config <CONFIG_FILE> --arch <KERNEL_ARCH> \ > --kernelsourcedir <PATH_TO_KERNEL_SOURCES> ><MODULE_NAME> must be "snapapi" for 2.4.x kernels or >"snapapi26" for 2.6.x kernels. -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
