Pankaj Batra wrote:
Sir/Madam
Please help me out.I have Red Hat 8 installed on the Xeon HCL server with 4 SCSI disk each 36 GB with RAID 5(harware) configured.
Two days back RAID degraded then i patched the Drives and rebuilded the RAID and then I boot the machine with rescue CD of Red hat CD 1.
but could not see the complete data on partitions. So i installed the OS again and i can retrieve the whole data.But i am facing one problem that when i shut down the server with init 0.
it stops at the following point.
......
......
Shutting down eth0 [OK]
Shutting down loopback interface [OK]
INIT: no more processes left in this runlevel.
This is correct bahaviour, you told the box to halt, not to reboot (init
6 is reboot)
from /etc/inittab
# Default runlevel. The runlevels used by RHS are:
# 0 - halt (Do NOT set initdefault to this)
# 1 - Single user mode
# 2 - Multiuser, without NFS (The same as 3, if you do not have
networking)
# 3 - Full multiuser mode
# 4 - unused
# 5 - X11
# 6 - reboot (Do NOT set initdefault to this)
Also, using redhat 8 would be a bad idea - it is exceptionally out of
date and even security fixes are no longer released, I'd advise you to
update it to something a little more recent. Generally a minimal install
and then adding the packages you need will still work well on older
hardware.
--
Steve
() ascii ribbon campaign - against html e-mail
/\ www.asciiribbon.org - against proprietary attachments
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
