I have just set up all of my Redhat Linux machines to use ntp time synchronisation off a couple of servers. All but two of the machines have worked fine. The two machines that do not work are the only ones running 64-bit RHEL4 all the others are 32bit so there must be something different on these machines. The output i get from the ntpq -p command is below: remote refid st t when poll reach delay offset jitter ============================================================================== Server 1 Server 2 4 u 4 16 377 76.417 -3.881 8.292 Server 2 .RSTR. u - 16 0 0.000 0.000 4000.00 The .RSTR. is stopping the communication, which stops the synchronisation. Has anyone seen this before, if so what does it mean and what can i do to rectify the issue. Regards Andrew Bridgeman ********************************************************************** This transmission is confidential and must not be used or disclosed by anyone other than the intended recipient. Neither Corus Group Limited nor any of its subsidiaries can accept any responsibility for any use or misuse of the transmission by anyone. For address and company registration details of certain entities within the Corus group of companies, please visit http://www.corusgroup.com/entities ********************************************************************** -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
