I have recently changed the Raid settings on my Redhat machine so that it uses Raid 1+0 instead of just raid 0. When i go to a command prompt and run a df -h i cannot see the hard disk devices which normally appear as /dev/cciss/c0d0 etc etc. I am running in rescue mode to try and solve this issue. Does anyone know how a can get the disks to be seen? What can i check for? P.s I have another machine that is up currently using raid 1+0, how can i check that machine to make sure i have put the raid settings in correctly on the one that does not work? Any help would be much appreciated. Regards Andrew Bridgeman ********************************************************************** This transmission is confidential and must not be used or disclosed by anyone other than the intended recipient. Neither Corus Group Plc nor any of its subsidiaries can accept any responsibility for any use or misuse of the transmission by anyone. ********************************************************************** -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
