Hi,
We are using Broadcom NetXtreme BCM5721 NIC on our sun fire x2100 with
RH4 UPDATE3.
We have a lot of connectivity issues with these and we cannot configure
them in full duplex mode.
Driver in tg3 fully supported.
"ethtool -s eth1 duplex full" giev a return code 0.
"mii-tool -F 100baseTx-FD eth1" is ok as well.
but
lshw: description: Ethernet interface
product: NetXtreme BCM5721 Gigabit Ethernet PCI Express
vendor: Broadcom Corporation
physical id: 0
bus info: pci@04:00.0
logical name: eth1
version: 11
serial: 00:e0:81:5b:e2:f1
size: 100MB/s
capacity: 1GB/s
width: 64 bits
clock: 33MHz
capabilities: bus_master cap_list ethernet physical mii
10bt 10bt-fd 100bt 100bt-fd 1000bt 1000bt-fd a
utonegotiation
configuration: autonegotiation=on broadcast=yes driver=tg3
driverversion=3.10 duplex=half ip=172.16.8.
100 link=yes multicast=yes port=twisted pair speed=100MB/s
Anyone faced problems configuring the tg3 driver to full duplex?
Thanks,
Christophe.
--
redhat-list mailing list
unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
