Please check the irq on both cards they should not be the same. Change the irq both cards can not be using the same irq on the same machine... -----Original Message----- From: redhat-list-bounces@xxxxxxxxxx [mailto:redhat-list-bounces@xxxxxxxxxx] On Behalf Of Ong Ying Ying Sent: Thursday, March 30, 2006 7:34 AM To: General Red Hat Linux discussion list Subject: Re: Kudzu cannot detect 2nd network card Greg Golin wrote: > What card is this? Who is the vendor and what is the model? I suggest > you check whether the vendor provides newer drivers -- Seawolf is > quite old. You could also try and boot with a live cd, or to a rescue > mode of a later distribution install, and see if both cards get > initialized. > isapnp: Card 'Relia RE-2019 plug & Play Ethernet card' NE*000 ethercard probe at 0x240: 00 c0 0c 50 ... eth0: NE2000 ... using IRQ 10 Both card are the same type of card. Both are ok as they can be used on one same isa port. The other isa port cannot detect both of them so I guess it is spoilt. Do isa ports need drivers or controllers? There's no place to enable second NIC nor isa port in BIOS. PCI, Serial, Parallel and IDE have in BIOS. > G > > On 3/29/06, Oluwagbega Shobowale <gshobowale@xxxxxxxxxxxxxxxx> wrote: > >>I think you should check if the network card is functional if it is >>check that the slot if working also. Then do your test again >> >>-----Original Message----- >>From: redhat-list-bounces@xxxxxxxxxx >>[mailto:redhat-list-bounces@xxxxxxxxxx] On Behalf Of Ong Ying Ying >>Sent: Wednesday, March 29, 2006 4:16 PM >>To: redhat-list@xxxxxxxxxx >>Subject: Kudzu cannot detect 2nd network card >> >> >>I am using Redhat 7.1 (Seawolf), Linux ver 2.4.2-2. >> >>I have 2 network cards in my computer but kudzu detected 1 card only. >>Why? ifconfig showed eth0 and lo only. >> >>Then, I setup 2 interface in Network Configurator in X-Win and reboot. >>Kudzu still didn't detect and 'modprobe: Can't locate module eth1' at >>Bringing up eth1. eth1 cannot be activated on startup but it can be >>activate in X but cannot save. >> >>So how do I configure the other network card? Both the network cards >>are the same. Network Configuration in Text Mode Setup can enter 1 IP >>only. dmesg shows 1 network card only. >> >>Thanks in advance. >> >> >>-- >>redhat-list mailing list >>unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe >>https://www.redhat.com/mailman/listinfo/redhat-list >> >>-- >>redhat-list mailing list >>unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe >>https://www.redhat.com/mailman/listinfo/redhat-list >> -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
