"That doesn't work, either. All of the mtx commands give the same error as `mtx -f /dev/sg0 status` (below), including load." A few things to check for: 1) Is the library Attached? dmesg | grep Attached This should return something like the following: Attached scsi tape st0 at scsi0, channel 0, id 1, lun 0 Attached scsi generic sg0 at scsi0, channel 0, id 0, lun 0, type 8 Type 8 is a library device 2) Check your SCSI ID's In general I prefer to set the library to SCSI ID 0 and the tape drives to the next numbers, so Tape Drive 1 might be SCSI ID 1 3) Make sure you are not using luns. Last time I checked RH 3 does not have multiple lun support compiled into the kernel 4) Do not have the tape library connected to a MegaRAID or any other SCSI RAID adapter, Use an independant SCSI card 5) If for some reason 1) does not work, you may be able to modprobe sg and that will find it. I have seen cases where /etc/hotplug/scsi.agent has an incorrect spelling for the MODULES name for sg. I believe it was spelled MOUDLES. __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
