I have searched and maybe I didn't use the right string but I can't seem to find a solution to this problem. I have and am trying to install FC3 on the following Tyan 1836 Dual PIII 500 512MB ECC I know as best I can that the media is good. I have used them for a simple install on a single drive PC. a mix of 2 IBM 9GB (sda,sdb) and 2 IBM 18GB (sdc, sdd) SCSI drives with various RAID partitions. I have / raid1 (of course) across the sdc & sdd as md0. I do not have a /boot partition. I am using the onboard Adaptec 7895p SCSI controller for the 4 drives. The machine boots up fine to the point where it says "Searching for boot recoed from SCSI..OK" and then hang there. I have looked at GRUB and all looks OK to me. Is there some issue I haven't seen discussed somewhere other than a general problem with GRUB on FC3 with some hardware setups? I would of course really like to resolve this and pointers? Thanks. -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subjecthttps://www.redhat.com/mailman/listinfo/redhat-list
