Thanks for the response, but... I found out that the systems were not patched with the latest kernel.... there is a bugzilla report about this issue and I was able to fix with the patches available on RHN. Thanks. ~smbinyon -----Original Message----- From: redhat-list-bounces@xxxxxxxxxx [mailto:redhat-list-bounces@xxxxxxxxxx]On Behalf Of Smith, Albert Sent: Thursday, February 17, 2005 7:14 AM To: General Red Hat Linux discussion list; redhat-list@redhat. com (E-mail) Subject: RE: TTL returning 0 when /proc/sys/net/ipv4/ip_default_ttl is 64???? > We are a simulation site that uses UDP broadcasting to send packets to > various sims. We been using RHL 9.0 with success, but with the upgrade to > RHEL-WS 3.3 we are now having problems with tcp TTL being set to 0. Looking > at /proc/sys/net/ipv4/ip_default_ttl it shows a value of 64. But yet via > ethereal the time to live field shows 0 for all UDP packets. This also > appears on broadcast pings with TTL showing 0. This does not occur on any > of the RHL 9.0, only on the RHEL-WS systems. > To add, these systems have multiple interfaces (3), Intel and 3Com type > cards and that these are UDP packets. Is there something new under RHEL > that is preventing UDP packets to have a TTL greater than 0? Is there a way > to set TTL for UDP?? Any help would be appreciated. If more info is > needed, I be happy to give. > > Thanks. > > Steve Binyon > System Administrator > DMOC > (505)853-0368 Steve, Modify /etc/sysctl.conf and hardcode the following line: net.ipv4.ip_default_ttl = 64 save/exit then do a sysctl -e -p This will reset the values in /proc to their boot values plus add the change. This will hard set the TTL to 64. There is no default setting that I see for UDP only. I would check to see if you have your firewall running. just type lokkit at the prompt and if it's enabled, disable it then do: service iptables stop this should shutdown your firewall altogther. If this doesn't work check the firewall on the receiving host and make sure it's allowed to send out pings and such. If that doesn't work check with your network admin to see if UDP is blocked on the local network. Albert Smith Sr. Unix Systems Administrator Genex Services 440 E. Swedesford Rd. Wayne, PA 19087 albert.smith@xxxxxxxxxxxxxxxxx (610) 964-5154 -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
