Im having a difficult time implementing a new kernel
I do bzip2 -dc linux-2.6.0.tar.bz2 | tar xvf - make menuconfig make bzImage make modules make modules_install make install
Researching my error I found this http://www.redhat.com/archives/fedora-list/2004-November/msg03120.html
" 2. Navigate through the menus: "Device Drivers -> Block Devices" 3. Enable "RAM disk support", and "Initial RAM disk (initrd) support" 4. Enable any other kernel stuff you want/need. 5. Run "make", then (as root) "make modules_install", and "make install"
The "make install" will create your initrd and add the appropriate stanza in your /boot/grub/grub.conf.
make install
"
I do not run the original "make" but rather make bzImage
This does exactly that
the new kernel and image are copied to /boot
grub is "automagically" edited
but... I still end up with the "kernel panic no init found - Try passing init= to kernel"
Any Ideas what i may be doing wrong?
Thanks Bob
-- "Oracle error messages being what they are, do not highlight the correct cause of fault, but will identify some other error located close to where the real fault lies."
-- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
