Did
you add a route to the network? your Routing table needs to know where to
go.
route
add -net 0.0.0.0 gw GATEWAYIP netmask 255.255.255.0 INTERFACE_ALIAS
(eth0)
You
can add it to the /etc/rc.local to preserve on reboot.
Tim Pickard
Systems Support Analyst and Administrator
40
Salem Street
Lynnfield, MA
01940
p.781-295-0072
f.781-295-0077
tpickard@xxxxxxxxxxxx
-----Original Message-----
From: Johnson, Shaunn [mailto:SJohnson6@xxxxxxxxx]
Sent: Wednesday, April 28, 2004 2:50 PM
To: 'General Red Hat Linux discussion list'
Subject: RE: new to list / network eth0 issue--thanks all.
--both mii-tool and ethtool are on RHEL v. 3 - they both look
--great; i have made the change, but i still can not reach
--the server. i think the IS team has made an error - it
--may be the switch, but that just seems silly ---i'm beginning to think it's either windows 200x or just
--add the 2nd card and route my way around it.--will work on it - thanks again!
-X
-----Original Message-----
From: Jeff [mailto:jeff@xxxxxxxxxx]
[snip]
not sure if the same applies on RHEL but in RH9,
just run 'ethtool' as root - dead simple to use.HTH
Jeff
-- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
