Your question seems a little vague but you may want to look at this link.. http://homepages.fh-regensburg.de/~jom30197/ What you are asking for here does not really appear to make a lot of sense - things such as IPv4 vs IPv6 are ok to compare, as these tend to be similar things (IP Stacks) but IPsec happens at a different layer unless you are talking about comparing IPv4 with no IPsec vs IPv4 with IPsec with the tunnels terminating on the device you are testing and the encapsulation happening there. The processes then would tend to be CPU bound, not protocol stack bound so repeating the same tests with IPv6 should produce the same differences which show the overhead with adding IPsec encryption to the system. You also need to ensure that you are not testing dissimilar systems, and if the link above has truth to it, you may get slightly improved throughput/performance using an IPv6 stack over an IPv4 one, but it is again very subjective and the difference in values are probably negigable in 99.9% of all environments. (also note - RedHat Linux or another brand of linux will produce extremely similar statistics - the one used above was SuSe but one linux is essentually the same for these purposes.) -- Steve. > > Hello everybody, > > Good day to every body. > > Could any body share the Linux stack Ipv6 raw performance results/numbers > in > red hat linux platform. > > the performance parameters are - > > Ipv6 forwarding (with ipsecurity/without)- > Latency(with ipsec/with)- > Throughput(with ipsec/without)- > > -Thanks and warm regds, > Srinivas .k > > > > > > > *************************************************************************** > This message is proprietary to Future Software Limited (FSL) > and is intended solely for the use of the individual to whom it > is addressed. It may contain privileged or confidential information > and should not be circulated or used for any purpose other than for > what it is intended. > > If you have received this message in error, please notify the > originator immediately. If you are not the intended recipient, > you are notified that you are strictly prohibited from using, > copying, altering, or disclosing the contents of this message. > FSL accepts no responsibility for loss or damage arising from > the use of the information transmitted by this email including > damage from virus. > *************************************************************************** > > > -- > redhat-list mailing list > unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe > https://www.redhat.com/mailman/listinfo/redhat-list > -- redhat-list mailing list unsubscribe mailto:redhat-list-request@xxxxxxxxxx?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list
