Hi,
This is the next iteration of the patchset that added the discard
option to mdadm. Per feedback from Martin, it's more desirable
to use the write-zeroes functionality than rely on devices to zero
the data on a discard request. This is because standards typically
only require the device to do the best effort to discard data and
may not actually discard (and thus zero) it all in some circumstances.
This version of the patch set adds the --write-zeroes option which
will imply --assume-clean and write zeros to the data region in
each disk before starting the array. This can take some time so
each disk is done in parallel in its own fork. To make the forking
code easier to understand this patch set also starts with some
cleanup of the existing Create code.
We tested write-zeroes requests on a number of modern nvme drives of
various manufacturers and found most are not as optimized as the
discard path. A couple drives that were tested did not support
write-zeroes at all but still performed similarly with the kernel
falling back to writing zero pages. Typically we see it take on the
order of one minute per 100GB of data zeroed.
One reason write-zeroes is slower than discard is that today's NVMe
devices only allow about 2MB to be zeroed in one command where as
the entire drive can typically be discarded in one command. Partly,
this is a limitation of the spec as there are only 16 bits avalaible
in the write-zeros command size but drives still don't max this out.
Hopefully, in the future this will all be optimized a bit more
and this work will be able to take advantage of that.
Logan
--
Changes since v3:
* Store the pid in a local variable instead of the mdinfo struct
(per Mariusz and Xiao)
Changes since v2:
* Use write-zeroes instead of discard to zero the disks (per
Martin)
* Due to the time required to zero the disks, each disk is
now done in parallel with separate forks of the process.
* In order to add the forking some refactoring was done on the
Create() function to make it easier to understand
* Added a pr_info() call so that some prints can be done
to stdout instead of stdour (per Mariusz)
* Added KIB_TO_BYTES and SEC_TO_BYTES helpers (per Mariusz)
* Added a test to the mdadm test suite to test the option
works.
* Fixed up how the size and offset are calculated with some
great information from Xiao.
Changes since v1:
* Discard the data in the devices later in the create process
while they are already open. This requires treating the
s.discard option the same as the s.assume_clean option.
Per Mariusz.
* A couple other minor cleanup changes from Mariusz.
*** BLURB HERE ***
Logan Gunthorpe (7):
Create: goto abort_locked instead of return 1 in error path
Create: remove safe_mode_delay local variable
Create: Factor out add_disks() helpers
mdadm: Introduce pr_info()
mdadm: Add --write-zeros option for Create
tests/00raid5-zero: Introduce test to exercise --write-zeros.
manpage: Add --write-zeroes option to manpage
Create.c | 479 ++++++++++++++++++++++++++++-----------------
ReadMe.c | 2 +
mdadm.8.in | 16 ++
mdadm.c | 9 +
mdadm.h | 7 +
tests/00raid5-zero | 12 ++
6 files changed, 350 insertions(+), 175 deletions(-)
create mode 100644 tests/00raid5-zero
base-commit: 8b668d4aa3305af5963162b7499b128bd71f8f29
--
2.30.2
