Hello, we've noticed an interesting behavior when using a raid-0 md array. Suppose we have a 2-disk raid-0 array that has a mount point set - in our tests, we've used ext4 filesystem. If we remove one of the component disks via sysfs[0], userspace is notified, but mdadm tool fails to stop the array[1] (it cannot open the array device node with O_EXCL flag, hence it fails to issue the STOP_ARRAY ioctl). Even if we circumvent the mdadm O_EXCL open, md driver will fail to execute the ioctl given the array is mounted. As a result, the array keeps mounted and we can even read/write from it, although it's possible to observe filesystem errors on dmesg[2]. Eventually, after some _minutes_, the filesystem gets remounted as read-only. During this weird window in which the array had a component disk removed but is still mounted/active (and accepting read/writes), we tried to perform reads and writes and sync command, which "succeed" (meaning the commands themselves didn't fail, although the errors were observed in dmesg). When "dd" was executed with "oflag=direct", the writes failed immediately. This was observed with both nvme and scsi disks composing the raid-0 array. We've started to pursue a solution to this, which seems to be an odd behavior. But worth to check in the CC'ed lists if perhaps this is "by design" or if it was already discussed in the past (maybe an idea was proposed). Tests were executed with v4.17-rc2 and upstream mdadm tool. Thanks in advance, Guilherme [0] To remove the array component disk, we've used: a) For nvme: "echo 1 > /sys/block/nvme0n1/device/device/remove" b) For scsi: "echo 1 > /sys/block/sda/device/delete" [1] mdadm tool tries to fail the array by executing: "mdadm -If <component_block_device>" [2] Example: [...] [88.719] Buffer I/O error on device md0, logical block 157704 [88.722] Buffer I/O error on device md0, logical block 157705 [88.725] EXT4-fs warning (device md0): ext4_end_bio:323: I/O error 10 writing to inode 14 (offset 0 size 8388608 starting block 79744) [88.725] EXT4-fs warning (device md0): ext4_end_bio:323: I/O error 10 writing to inode 14 (offset 0 size 8388608 starting block 80000) [...] -- To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
