On 24/04/13 18:26, Andrei Banu wrote: > Hello, > > I am sorry for the irrelevant feedback. Where I misunderstood your > request, I filled in the blanks (poorly). > > 1. SWAP > root [~]# blkid | grep cef1d19d-2578-43db-9ffc-b6b70e227bfa > /dev/md1: UUID="cef1d19d-2578-43db-9ffc-b6b70e227bfa" TYPE="swap" > > So yes, swap is on md1. This *md1 has a size of 2GB*. Isn't this way > too low for a system with 16GB of memory? > Provide the output of "free", if there is RAM available, then it isn't too small (that is my personal opinion, but at least it won't affect performance/operations until you are using most of that swap space). > > 3. root [~]# fdisk -lu /dev/sd* > My mistake, I should have said: fdisk -lu /dev/sd? In any case, all of the relevant information was included, so no harm done. > Disk /dev/sda: 512.1 GB, 512110190592 bytes > 255 heads, 63 sectors/track, 62260 cylinders, total 1000215216 sectors > Units = sectors of 1 * 512 = 512 bytes > Sector size (logical/physical): 512 bytes / 512 bytes > I/O size (minimum/optimal): 512 bytes / 512 bytes > Disk identifier: 0x00026d59 > > Device Boot Start End Blocks Id System > /dev/sda1 2048 4196351 2097152 fd Linux raid > autodetect > Partition 1 does not end on cylinder boundary. > /dev/sda2 * 4196352 4605951 204800 fd Linux raid > autodetect > Partition 2 does not end on cylinder boundary. > /dev/sda3 4605952 814106623 404750336 fd Linux raid > autodetect > > Disk /dev/sdb: 512.1 GB, 512110190592 bytes > 255 heads, 63 sectors/track, 62260 cylinders, total 1000215216 sectors > Units = sectors of 1 * 512 = 512 bytes > Sector size (logical/physical): 512 bytes / 512 bytes > I/O size (minimum/optimal): 512 bytes / 512 bytes > Disk identifier: 0x0003dede > > Device Boot Start End Blocks Id System > /dev/sdb1 2048 4196351 2097152 fd Linux raid > autodetect > Partition 1 does not end on cylinder boundary. > /dev/sdb2 * 4196352 4605951 204800 fd Linux raid > autodetect > Partition 2 does not end on cylinder boundary. > /dev/sdb3 4605952 814106623 404750336 fd Linux raid > autodetect > I'm assuming from this you have three md RAID1 arrays where sda1/sdb1 are a pair, sda2/sdb2 are a pair and sda3/sdb3 are a pair? Can you describe what is on each of these arrays? Output of cat /proc/mdstat df pvs lvs Might be helpful.... Regards, Adam -- Adam Goryachev Website Managers www.websitemanagers.com.au -- To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
