Re: Huge values of mismatch_cnt on RAID 6 arrays under Fedora 18

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Dear Robin Hill,

In message <20130127200557.GA10960@xxxxxxxxxxxxxxxxxxxxxxxxxxxx> you wrote:
> 
> Is this after having run a check, or just after boot? I've seen some odd
> numbers at times, but they've gone away after running a check
> (presumably something not being initialised).

The non-zero mismatch_cnt was reported by a check, and after that I
looked at the state of the array.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd@xxxxxxx
People are always a lot more complicated than you  think.  It's  very
important to remember that.             - Terry Pratchett, _Truckers_
--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux RAID Wiki]     [ATA RAID]     [Linux SCSI Target Infrastructure]     [Linux Block]     [Linux IDE]     [Linux SCSI]     [Linux Hams]     [Device Mapper]     [Device Mapper Cryptographics]     [Kernel]     [Linux Admin]     [Linux Net]     [GFS]     [RPM]     [git]     [Yosemite Forum]


  Powered by Linux