Re: How does one assemble a DDF or IMSM array?

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi,

you can start them by using "mdadm -As", that will start up the container first and the other md devices after. This will work without mdadm.conf, but it is always good to create a proper mdadm.conf (mdadm -Es > /etc/mdadm.conf).

As for what it is, the container contains the disks (in your case sda and sdb), the disks are not the container.

So you create a container first:
mdadm -CR /dev/md127 -e ddf -l container -n 2 /dev/sda /dev/sdb
Create a RAID1 device of 1 GB in there
mdadm -CR /dev/md0 -l 1 -n 2 /dev/md127 -z  1G
Create another RAID1 device of 50 MB in there
mdadm -CR /dev/md1 -l 1 -n 2 /dev/md127 -z 50M

(in this case both md devices are created on the same two disks).

If you have e.g. 5 disks you can create two separate RAID1 and RAID5 devices in the container:

mdadm -CR /dev/md127 -e ddf -l container -n 2 /dev/sda /dev/sdb /dev/sdc /dev/sdd /dev/sde
mdadm -CR /dev/md0 -l 1 -n 2 /dev/md127
mdadm -CR /dev/md1 -l 5 -n 3 /dev/md127

Now, two disk are used fully for the RAID 1 device and three fully for the RAID 5 devices, they both have their own set of disks.


Stopping them all:
mdadm -Ss

Starting them all:
mdadm -As

Hope this helps,

Albert


On 08/03/2012 03:05 AM, Wakko Warner wrote:
I've not used DDF or IMSM arrays much.

I understand that the devices (ie /dev/sda and /dev/sdb) are the containers.

I know that one can use mdadm -I on the devices and it will create mdXXX
(last I tried it was 127) and then will create mdXXX for each virtual disk
in the container and they will just work.

If I do mdadm -A /dev/mdXXX, how would one get the volumes inside started?
I tried mdadm -I /dev/mdXXX after mdadm -A.  It created mdXXX where XXX is
-2 from the first one (it 127 being the container and 125 being there but
not in a state that works)

Does DDF/IMSM require mdadm.conf to work when using -A?

I'm not sure if I'm making myself very clear here or not.


--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html


[Index of Archives]     [Linux RAID Wiki]     [ATA RAID]     [Linux SCSI Target Infrastructure]     [Linux Block]     [Linux IDE]     [Linux SCSI]     [Linux Hams]     [Device Mapper]     [Device Mapper Cryptographics]     [Kernel]     [Linux Admin]     [Linux Net]     [GFS]     [RPM]     [git]     [Yosemite Forum]


  Powered by Linux