On 19/04/2011 15:25, Mathias BurÃn wrote:
On 19 April 2011 14:21, David Brown<david@xxxxxxxxxxxxxxx> wrote:
I have recently got an IBM x3650 M3 server, which has a "Serveraid M5014"
raid controller. Booting from a Linux CD (system rescue CD) and running
lspci identifies this raid controller as:
LSI Logic/Symbus Logic Megaraid SAS 2108 [Liberator] (rev 03)
The controller works fine for hardware raid - I can open its bios setup
utility, and set up a RAID5 (or whatever) with the disks I have. The OS
then just sees a single virtual disk.
But I would like direct access to the sata drives - I want to set up mdadm
raid, under my own control. As far as I can see, there is no way to put
this controller into "JBOD" or "direct access" mode of any sort.
Does anyone here have experience with this card, or can give me any hints?
The only idea I have at the moment is to put each disk within its own
single-disk RAID 0 set, but then I don't get sata hot-swap functionality,
SMART, hddtemp, etc.
Thanks for any clues or hints,
David
Regarding SMART, could you try (after loading the appropriate
megaraid/megasas module) hdparm -a -d megaraid,$I /dev/sda , where $I
is a number between 0 and 31 IIRC (depending on the HDD in the array).
Are you sure about the syntax for that command? Trying that with "0"
for $I just gives me "megaraid,0: No such file or directory". As far as
I can see, the megaraid module is loaded (lsmod shows "megaraid_sas" in
the modules list).
Thanks anyway,
David
--
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
