Al Boldi wrote:
Bill Davidsen wrote:
Al Boldi wrote:
The problem is that raid1 one doesn't do striped reads, but rather uses
read-balancing per proc. Try your test with parallel reads; it should
be faster.
:
:
It would be nice if reads larger than some size were considered as
candidates for multiple devices. By setting the readahead larger than
that value speed increases would be noted for sequential access.
Actually, that's what I thought for a long time too, but as Neil once pointed
out, for striped reads to be efficient, each chunk should be located
sequentially, as to avoid any seeks. This is only possible by introducing
some offset layout, as in raid10, which infers a loss of raid1's
single-disk-image compatibility.
I can't imaging that the offset needs to be physical, there's a
translation done from the chunk address on the array to the physical
address on the drive, and beyond that usually a translation from the
logical position in a partition to a physical LBA location on the drive
as a whole.
What could be feasible, is some kind of an initial burst striped readahead,
which could possibly improve small reads < (readahead * nr_of_disks).
You are correct, but I think if an optimization were to be done, some balance between the read time, seek time, and read size could be done. Using more than one drive only makes sense when the read transfer time is significantly longer than the seek time. With an aggressive readahead set for the array that would happen regularly.
It's possible, it just takes the time to do it, like many other "nice" things.
--
bill davidsen <davidsen@xxxxxxx>
CTO TMR Associates, Inc
Doing interesting things with small computers since 1979
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
