On Sat, 12 Aug 2006, Chuck Ebbert wrote:
Doing this on a raid1 array:
echo "check" >/sys/block/md0/md/sync_action
On 2.6.16.27:
Activity lights on both mirrors show activity for a while,
then the array status prints on the console.
On 2.6.18-rc4 + the below patch:
Drive activity light blinks once on one drive, then the
array status prints (obviously no checking takes place.)
Applied hotfix on 2.6.18-rc4:
--- .prev/drivers/md/md.c 2006-08-08 09:00:44.000000000 +1000
+++ ./drivers/md/md.c 2006-08-08 09:04:04.000000000 +1000
@@ -1597,6 +1597,19 @@ void md_update_sb(mddev_t * mddev)
repeat:
spin_lock_irq(&mddev->write_lock);
+
+ if (mddev->degraded && mddev->sb_dirty == 3)
+ /* If the array is degraded, then skipping spares is both
+ * dangerous and fairly pointless.
+ * Dangerous because a device that was removed from the array
+ * might have a event_count that still looks up-to-date,
+ * so it can be re-added without a resync.
+ * Pointless because if there are any spares to skip,
+ * then a recovery will happen and soon that array won't
+ * be degraded any more and the spare can go back to sleep then.
+ */
+ mddev->sb_dirty = 1;
+
sync_req = mddev->in_sync;
mddev->utime = get_seconds();
if (mddev->sb_dirty == 3)
--
Chuck
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
Is there a doc for all of the options you can echo into the sync_action?
I'm assuming mdadm does these as well and echo is just another way to run
work with the array?
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
