Gordon Mohr (@ Bitzi) wrote:
My 'mdadm' (v1.6.0) man page includes:
# -z, --size=
# Amount (in Kibibytes) of space to use from each
drive in
# RAID1/4/5/6. This must be a multiple of the chunk
size, and
# must leave about 128Kb of space at the end of the drive
for the
# RAID superblock. If this is not specified (as it
normally is
# not) the smallest drive (or partition) sets the size,
though if
# there is a variance among the drives of greater than
1%, a
# warning is issued.
There are several problems when trying to interpret the phrase "This
must be a
multiple of the chunk size, and must leave about 128Kb of space at the
end of
the drive for the RAID superblock."
(1) Someone resizing an array may not know the chunk size, and it's unclear
if assuming the default of 64 is OK, or dangerous. (My experiments show
that
'mdadm' will accept a size value that is not a multiple of 64, and will
update
the array size as shown by --detail to this non-multiple size, at least for
RAID1. Does this risk disaster?)
RAID1 doesn't use chunk size, so chunk size is completely irrelevant
here. But, for the RAID levels that use chunk size, things are handled
correctly -- mdadm will round the size to a chunk multiple.
(2) "Kb" is technically the abbrieviation of "kilobits", not
"kibibytes". I'm
assuming "128Kb" means "128 kibibytes" from the preceding context. I
suggest
avoiding the abbrieviation entirely to avoid confusion.
(3) To "leave" space is ambiguous in what it means for the value specified.
Should the we take the amount of space needed for our filesystem and add
128K
to get the 'size' value to specify? Or specify exactly what's needed for
the filesystem, and be aware that RAID will actually use 128K more on
the consitutent devices than what was specified? (I *think* the second is
meant, but I'm not sure.)
Yes. You are specifying the "data" size. The superblock will be located
somewhere in the 128KB past the data.
(4) The imprecise "about 128Kb" raises the question: is more than 128K
sometimes needed? If I "leave" exactly 128K, is that a recipe for eventual
disaster when someday the superblock goes over this allotment?
No. The superblock takes 4K. The thing that makes the 128KB number
variable is the algorithm used to locate the superblock. The superblock
is always placed between 64 and 128 KB from the end of the disk:
super_location = disk_size - (disk_size % 64KB) - 64KB
All this being said, you rarely need to actually specify the array size.
mdadm is smart enough to figure all this out and use all available disk
capacity, which is almost always what you want.
--
Paul
-
To unsubscribe from this list: send the line "unsubscribe linux-raid" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
