On Thursday 19 August 2004 19:52, PAulN wrote: > Guy, > thanks for the snappy reply! I wish my disks were as fast :) > I failed to mention that I had been tweaking those proc values. Currently > they are: > (root@lcn0:raid)# cat speed_limit_max > 200000 > (root@lcn0:raid)# cat speed_limit_min > 10000 > > If I'm correct, this means that the min speed is 10MB/sec per device. > I've verified that each device has a seq write speed of about 38MB/sec so > each should be capable of handling 10,000Kbytes sec. Right after I issue > a raidstart the speed is pretty good (~30MB/sec) but is just falls until > it hits > around 300K. > > md0 : active raid5 sdh1[7] sdf1[6] sdg1[5] sde1[4] sdd1[3] sdc1[2] > sdb1[1] sda1[0] > 481949184 blocks level 5, 64k chunk, algorithm 2 [7/7] [UUUUUUU] > [>....................] resync = 2.4% (1936280/80324864) > finish=4261.4min speed=305K/sec Something like this happened to me a while ago. The speed is good at start, then after a certain amount of time starts degrading until very very low, like 5k/sec. It keeps ever decreasing. Also, the decrease of speed occurred at exactly the same point every time. After a lot of searching, asking and bitching the true reason was revealed; one of the disks had problems and couldn't read/write a part of its surface. Only when I ran dd on it (and saw the read errors reported) did I realize that. So if what you are seeing is this ever-decreasing speed, starting at a specific point, I'd strongly concur with Guy in saying: Test each disk separately by reading /and or writing its _entire_ surface using the dd commands suggested. Not using hdparm or benchmarks, but reading the entire disk(s) as described. The purpose of this is NOT that you get an idea of the speed, but that you verify that the entire surface is still ok. Beyond that, I have no suggestions to offer you. Maarten - To unsubscribe from this list: send the line "unsubscribe linux-raid" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
