On 10.04.2017 16:23, Tanu Kaskinen wrote:
> On Sat, 2017-04-08 at 20:34 +0200, Georg Chini wrote:
>> If source or sink are changed, the current sink input rate may be different
>> from the default rate. Switch sink input rate back to default to avoid the
>> influence of the previous combination of source and sink.
>> ---
>> src/modules/module-loopback.c | 18 +++++++++++++++---
>> 1 file changed, 15 insertions(+), 3 deletions(-)
>>
>> diff --git a/src/modules/module-loopback.c b/src/modules/module-loopback.c
>> index 2242c62c..535c27d2 100644
>> --- a/src/modules/module-loopback.c
>> +++ b/src/modules/module-loopback.c
>> @@ -639,11 +639,18 @@ static void source_output_moving_cb(pa_source_output *o, pa_source *dest) {
>>
>> /* Send a mesage to the output thread that the source has changed.
>> * If the sink is invalid here during a profile switching situation
>> - * we can safely set push_called to false directly. */
>> - if (u->sink_input->sink)
>> + * we can safely set push_called to false directly. Also, the current
>> + * sampling rate may be far away from the default rate if we are still
>> + * recovering from a previous source or sink change, so reset rate to
>> + * default before moving the source. If the sink is not valid, only
>> + * update the sink input sample spec.*/
>> + if (u->sink_input->sink) {
>> pa_asyncmsgq_send(u->sink_input->sink->asyncmsgq, PA_MSGOBJECT(u->sink_input), SINK_INPUT_MESSAGE_SOURCE_CHANGED, NULL, 0, NULL);
>> - else
>> + pa_sink_input_set_rate(u->sink_input, u->source_output->sample_spec.rate);
>> + } else {
>> u->output_thread_info.push_called = false;
>> + u->sink_input->sample_spec.rate = u->source_output->sample_spec.rate;
>> + }
> pa_sink_input_set_rate() does other things too than just set
> sample_spec.rate. I think you should always call
> pa_sink_input_set_rate(), but since pa_sink_input_set_rate() currently
> doesn't expect to be called in the middle of a move, it needs to be
> fixed first.
>
I don't understand why it should not be enough to just set the sink
input rate.
This is also what is done before the sink input is put, so it should be
sufficient.
