On Mon, 2011-03-14 at 13:43 -0500, pl bossart wrote: > > I forced support for pulse1.0 it by hand in config.h and found the > > same problem with the headset. Trying to figure out the differences > > with my initial patches. there must be a step missing. > > ok, found a solution, see diff attached. For some reason the > setup_ad2p() did both the SBC and MPEG configuration. Adding a test > for the mode solves the issue, probably there was a buffer overflow or > something bad. Thanks! I was getting around to this view as well - the set_configuration seems to be failing because we're trying to set MPEG caps on the SBC seid. > playing with SBC and MPEG works fine now, meaning that the negotiation > works well depending on the payload. > but when I try to go back to PCM/SBC the second time I get the > following assert in pulseaudio (see gst log below) > E: module-bluetooth-device.c: Assertion 'u->write_memchunk.length == > u->block_size' failed at > modules/bluetooth/module-bluetooth-device.c:1519, function > a2dp_process_render(). Aborting. > > I'll let you debug this one, should be easier :-) :) ack. > Other things I noticed: the volume is much higher in passthrough mode, > maybe we need to find a way to set the volume on the headset to match > the volume used for PCM. Also I heard some high-frequency modulations, > typically coding noise, maybe there's still something fishy during the > mp3 decode part. I get this sort of thing on, as far as I can tell, one channel as well. I figured the decoder on the CSR chip wasn't that great. Cheers, Arun
