Hi, I have a USB soundcard as a stereo source in PulseAudio and want to send the audio as a RTP stream over the network. The two channels are unrelated (well not completely, one is the audio from the front-of-house mixing console and the other the combined signal from two room mics) so I would like to have two separate mono RTP streams. As far as I can see this is not possible with current PA. I can see two solutions. A new module-remap-source. So there can be two mono sources derived from each channel of the soundcard and I can set up two rtp-send modules. The other is to add a channel_map parameter to module-rtp send, so a mono rtp stream can come from any channel of the source, instead of only the mono channel. Which approach would be preferable? I could see the value in implementing both (eventually). A new module-remap-source would fix an obvious gap in the symmetry between sinks and sources, and could potentionally be useful in other scenario's too. I think I saw a bug report about the lack of a channel_map parameter for module-rtp-sink, so adding that to both rtp modules would be good too. Any thoughts on which steps to take? Maarten
