Hello everybody, I have noticed that the new pulseaudio volume logic sets the volume of my mixer elements in alsamixer to 100%. I always reduced the volume a little bit so that the audio isn't distorted, but nowadays pulseaudio setzt the volume back to 100%. There are two possible solution to my mind. 1) Is there a way to tell PA that it should set the volume of my channels [(PCM), Front, Surround, Center, LFE] to 94%? 2) I have noticed that PA only changes the volume of the Master mixer element if I change the volume in gnome. Wouldn't it be better if PA would change the volume of all 6 [Master, (PCM), Front, Surround, Center, LFE] mixer elements, then my problem would also disappear. Codec: Realtek ALC888 Address: 0 Function Id: 0x1 Vendor Id: 0x10ec0888 Subsystem Id: 0x14627521 Revision Id: 0x100001 pulseaudio: Installiert: 1:0.9.19-0ubuntu4 Kandidat: 1:0.9.19-0ubuntu4 Versions-Tabelle: *** 1:0.9.19-0ubuntu4 0 $ cat /proc/asound/version Advanced Linux Sound Architecture Driver Version 1.0.21. Compiled on Oct 15 2009 for kernel 2.6.31-14-generic (SMP). I have Flat-Volume activated. Power management is disabled. Regards Achim
