Colin Guthrie <gmane at colin.guthr.ie> wrote on 06/27/2009 01:54:37 PM: > 'Twas brillig, and Timothy J Massey at 27/06/09 18:13 did gyre and gimble: > > Finally, my last question is this: is there a way to control the actual > > name and description given to the original sink? Especially in the > > short-term, I don't mind having to statically configure the devices in, > > say, default.pa, even if that means I can't hot-plug new devices. I would > > certainly do this if there are CPU or quality advantages to not doing the > > module-remap-sink. > > Well the name you give it already via sink_name, but you can change the > description which will be shown in pavucontrol via the sink_properties= > argument to the module: > sink_properties="device.description='My Preferred Name'" I think you might have misinterpreted what I wrote. I'm not (yet) talking about module-combine. I'm using module-remap-sink. When I add the sink_properties parameter as written above to module-remap-sink, PA chokes on it. When I remove it, it is fine. Thank you for the patch (and tested patch) for module-combine. It will be helpful there--it's just as needed. But I'm hoping I can do something similar for module-remap-sink... Timothy J. Massey
