On Sun, Jan 27, 2008 at 02:47:22PM +0000, yatesy wrote: > I have a 2 Soundcard system :- > > Card 0 is "on-board" Intel HDA (ALC880 chip) and uses the ALSA > snd-hda-intel driver. > Card 1 is a MAudio Delta 44 and uses the ALSA ice1712 driver. > Both cards work fine using the "direct" ALSA interface. > > Using Pulseaudio the initialisation of the Delta 44 fails as follows : <snip> > Card 0 (ALC880) works fine with Pulseaudio (ESOUND & XMMS etc). > The above problem is the same on Ubuntu 7.10 & Hardy and also Fedora R8. > > I'm not sure if the above is a Pulseaudio or ALSA or configuration > problem ? > > Any ideas ? Automatic sound card detection isn't able to configure the Delta card correctly, the card seems to be a bit too exotic for that. So I'd say it's a HAL and/or PulseAudio problem. Since the configuration process succesfully manages to open the device - after much struggling - you probably can make it work with static device configuration. The thing that the configuration finally stumbles is that the channel map for the sink and source aren't valid. That's because there isn't a default channel map defined for 10 and 12 channels. So, what you'll have to do is edit /etc/pulse/default.pa. Comment out module-hal-detect and module-detect, and then add these lines (if you don't need the sources, leave them out): # Load the on-board device: load-module module-alsa-sink sink_name=intel-hda_out device=hw:0 load-module module-alsa-source source_name=intel-hda_in device=hw:0 # Load Delta 44: load-module module-alsa-sink sink_name=delta_out device=hw:1 channels=10 channel_map=left,right,aux0,aux1,aux2,aux3,aux4,aux5,aux6,aux7 load-module module-alsa-source source_name=delta_in device=hw:1 channels=12 channel_map=left,right,aux0,aux1,aux2,aux3,aux4,aux5,aux6,aux7,aux8,aux9 # Set the default sink and source (not mandatory, intel-hda # would probably be used without this): set-default-sink delta_out set-default-source delta_in That configuration makes Delta a stereo device, in the sense that if you play surround content, there will be sound only in the first two channels. If you want a surround setup (or want to have the stereo output on some other physical connector(), edit the channel maps. Valid channel names are listed in near the beginning of this page (under the "Device Drivers" heading): http://www.pulseaudio.org/wiki/Modules If you wonder why I didn't set the 'channels' argument of Delta to 2, that's because it seems that the device can't be opened for just two channels. The auto-configurator managed to open the device with 10 out and 12 in channels, that's why I'm using those values. This setup makes the assumption that the on-board device will always be hw:0 and Delta will be hw:1. This isn't necessary a valid assumption. -- Tanu Kaskinen
