I tried setting the routing table to direct to other interfaces but the packets keep appearing on the interface i didn't want. Each of the 4 rtp send modules goes to a different multicast address, so I figured that would be easy to route. It is fully possible that I was specifying the route incorrectly, so I will double check that. The reason for multicasting was allowing the sinks to connect to any of the four players while they were in operation, no interuption. That way any or all zones can connect to any mpd stream at will without interuption. It is very good to know though that the rtp module has no sync feedback (at least not to the crystal level). I have tested playing back 4 rtp receiver modules at once on the same machine and notice echoing effects, so I knew the sync wasn't perfect, but close, and probably good enough for room to room. I think I am going to investigate the combine module route more as per Tanu's suggestion. That should give me the better sink solution with hopefully tolerable processor/memory loads. I am on a core 2 duo machine, and all the outputs will be on one 8 channel sound card, so in theory syncing won't hurt too much. Thanks for the info Lennart. Matt Lennart Poettering wrote: > On Thu, 14.02.08 22:23, Matthew Patterson (matt at v8zman.com) wrote: > > >> Now for my question: This implementation obviously spews a lot of >> multicast traffic onto my network. I didn't think this would be a >> problem, but my router/ap/switch seems to crap out when it gets hammered >> with all the traffic. Is there any way that I can specify which >> interface pulesaudio sends its multicast packets on? >> > > Yes, it's called the "Routing Table" of your IP stack. Just use a > seperate mcast group for each destination. And then add routes for the > specific group to the right interface. > > Plese note that the RTP module doesn't deal with deviating > crystals. Might not be that great on the long run for the real Hifi > experience. > > >> Or even more ideally, can I disable all outgoing multicast traffic >> and just have the local loopback happening? >> > > Hmm? This makes no sense. Why would you use mcast then at all? > > Lennart > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.freedesktop.org/archives/pulseaudio-discuss/attachments/20080215/0d02167a/attachment.htm>
