The CCD temperature register is read in two places. These reads are done using an AMD SMN access, and a number of parameters are needed for the operation. Move the SMN access and parameter gathering into a helper function in order to simply the code flow. This also has a benefit of centralizing the hardware register access in a single place in case fixes or special decoding is required. Signed-off-by: Yazen Ghannam <yazen.ghannam@xxxxxxx> --- Link: https://lore.kernel.org/r/20230516202430.4157216-6-yazen.ghannam@xxxxxxx v1->v2: * Address comments from Guenter. drivers/hwmon/k10temp.c | 14 +++++++++----- 1 file changed, 9 insertions(+), 5 deletions(-) diff --git a/drivers/hwmon/k10temp.c b/drivers/hwmon/k10temp.c index 70f7b77e6ece..dfbba8b72f43 100644 --- a/drivers/hwmon/k10temp.c +++ b/drivers/hwmon/k10temp.c @@ -150,6 +150,13 @@ static void read_tempreg_nb_zen(struct pci_dev *pdev, u32 *regval) *regval = 0; } +static int read_ccd_temp_reg(struct k10temp_data *data, int ccd, u32 *regval) +{ + u16 node_id = amd_pci_dev_to_node_id(data->pdev); + + return amd_smn_read(node_id, ZEN_CCD_TEMP(data->ccd_offset, ccd), regval); +} + static long get_raw_temp(struct k10temp_data *data) { u32 regval; @@ -215,9 +222,7 @@ static int k10temp_read_temp(struct device *dev, u32 attr, int channel, *val = 0; break; case 2 ... 13: /* Tccd{1-12} */ - ret = amd_smn_read(amd_pci_dev_to_node_id(data->pdev), - ZEN_CCD_TEMP(data->ccd_offset, channel - 2), - ®val); + ret = read_ccd_temp_reg(data, channel - 2, ®val); if (ret) return ret; @@ -389,8 +394,7 @@ static void k10temp_get_ccd_support(struct pci_dev *pdev, * the register value. And this will incorrectly pass the TEMP_VALID * bit check. */ - if (amd_smn_read(amd_pci_dev_to_node_id(pdev), - ZEN_CCD_TEMP(data->ccd_offset, i), ®val)) + if (read_ccd_temp_reg(data, i, ®val)) continue; if (regval & ZEN_CCD_TEMP_VALID) -- 2.34.1