Hi All, On 8/25/22 12:44, Henning Schild wrote: > changes since v5: > - adding patch to convert to pr_fmt > - adding patch to prefix macros with "f7188x_" > - rebased p1v4 to be p3v5 and added tag > > changes since v4: > - remove int case from a printk in p1 > - include tags into commit messages > > changes since v3: > - update Kconfig as well > - drop chip names from comment in driver header > - add manufacturer check for Fintek again, Nuvoton not possible > - drop revision printing for Nuvoton > - restructure defines again > - add new model 427G > > changes since v2: (p1 only) > - rename macros that change behavior > - use chip type not device id in the macros > - reorder defines a bit > > changes since v1: > - remove unused define > - fix bug where (base + 2) was used as second data bit > - add macros for "inverted" and "single data bit" > > The first two patches apply some style refactorings before actual > functional changes are made. > > Later, This series enables a SuperIO GPIO driver to support a chip from > the vendor Nuvoton, the driver is for Fintek devices but those just are > very similar. And in watchdog and hwmon subsystems these SuperIO drivers > also share code and are sometimes called a family. > > In another step the individual banks receive a label to tell them apart, > a step which potentially changes an interface to legacy users that might > rely on all banks having the same label, or an exact label. But since a > later patch wants to use GPIO_LOOKUP unique labels are needed and i > decided to assign them for all supported chips. > > In a following patch the Simatic GPIO LED driver is extended to provide > LEDs in case that SuperIO GPIO driver can be loaded. > > Last but not least the watchdog module of that same SuperIO gets loaded > on a best effort basis. > > The very last patch enables a second model of that same board type. > > Henning Schild (7): > gpio-f7188x: switch over to using pr_fmt > gpio-f7188x: add a prefix to macros to keep gpio namespace clean > gpio-f7188x: Add GPIO support for Nuvoton NCT6116 > gpio-f7188x: use unique labels for banks/chips > leds: simatic-ipc-leds-gpio: add new model 227G > platform/x86: simatic-ipc: enable watchdog for 227G > platform/x86: simatic-ipc: add new model 427G Despite the "leds: simatic-ipc-leds-gpio: add new model 227G" missing an ack from the LED subsys maintainers I have decided to move forward with this. The LED changes in that patch are quite small / trivial, it actually touches both drivers/leds and drivers/platform/x86 and the latter changes are bigger and it also has been Reviewed by both me and Andy. So I'm going for the it is easier to ask for forgiveness then ... route here wrt the missing LEDs subsys ack. I've just pushed a new platform-drivers-x86-simatec branch which contains 6.0-rc1 + these 7 patches. Next I'm to send out a pull-req (based on a signed tag) to the involved subsys maintainers and merge that signed tag into my review-hans branch (and from there it will go to pdx86/for-next). Regards, Hans > > drivers/gpio/Kconfig | 3 +- > drivers/gpio/gpio-f7188x.c | 275 +++++++++++------- > drivers/leds/simple/simatic-ipc-leds-gpio.c | 42 ++- > drivers/platform/x86/simatic-ipc.c | 10 +- > .../platform_data/x86/simatic-ipc-base.h | 1 + > include/linux/platform_data/x86/simatic-ipc.h | 2 + > 6 files changed, 216 insertions(+), 117 deletions(-) >
