On most x86/ACPI devices there is no devicetree to supply the necessary
init-data. Instead the firmware already fully initializes the bq25890
charger at boot. To support this, add support for reading back the
settings from the chip through a new "linux,read-back-settings" boolean.
So far this new property is only used on x86/ACPI (non devicetree) devs,
IOW it is not used in actual devicetree files. The devicetree-bindings
maintainers have requested properties like these to not be added to the
devicetree-bindings, so the new property is deliberately not added
to the existing devicetree-bindings.
Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx>
---
Changes in v2:
- New patch in v2 of this series, together with the "linux,skip-reset" patch
this patch replaces the "ti,skip-init" patch from v1
---
drivers/power/supply/bq25890_charger.c | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/drivers/power/supply/bq25890_charger.c b/drivers/power/supply/bq25890_charger.c
index 7db32ceec108..ff8419945618 100644
--- a/drivers/power/supply/bq25890_charger.c
+++ b/drivers/power/supply/bq25890_charger.c
@@ -111,6 +111,7 @@ struct bq25890_device {
struct regmap_field *rmap_fields[F_MAX_FIELDS];
bool skip_reset;
+ bool read_back_init_data;
enum bq25890_chip_version chip_version;
struct bq25890_init_data init_data;
struct bq25890_state state;
@@ -662,7 +663,7 @@ static int bq25890_chip_reset(struct bq25890_device *bq)
static int bq25890_rw_init_data(struct bq25890_device *bq)
{
- bool write = true;
+ bool write = !bq->read_back_init_data;
int ret;
int i;
@@ -946,6 +947,10 @@ static int bq25890_fw_probe(struct bq25890_device *bq)
struct bq25890_init_data *init = &bq->init_data;
bq->skip_reset = device_property_read_bool(bq->dev, "linux,skip-reset");
+ bq->read_back_init_data = device_property_read_bool(bq->dev,
+ "linux,read-back-settings");
+ if (bq->read_back_init_data)
+ return 0;
ret = bq25890_fw_read_u32_props(bq);
if (ret < 0)
--
2.33.1
