Add support for capability register in order to distinct between the systems with minor LED configuration differences. It reduces the amount of code describing systems' LED configuration. For example one system can be equipped with six LED, while the other with only four. Reading this information from the capability registers allows to use the same LED structure for such systems and set the relevant configuration dynamically based on capability register content. Signed-off-by: Vadim Pasternak <vadimp@xxxxxxxxxxxx> --- drivers/leds/leds-mlxreg.c | 19 +++++++++++++++++++ 1 file changed, 19 insertions(+) diff --git a/drivers/leds/leds-mlxreg.c b/drivers/leds/leds-mlxreg.c index 1ee48cb21df9..cabe379071a7 100644 --- a/drivers/leds/leds-mlxreg.c +++ b/drivers/leds/leds-mlxreg.c @@ -22,6 +22,7 @@ #define MLXREG_LED_AMBER_SOLID 0x09 /* Solid amber */ #define MLXREG_LED_BLINK_3HZ 167 /* ~167 msec off/on - HW support */ #define MLXREG_LED_BLINK_6HZ 83 /* ~83 msec off/on - HW support */ +#define MLXREG_LED_CAPABILITY_CLEAR GENMASK(31, 8) /* Clear mask */ /** * struct mlxreg_led_data - led control data: @@ -187,6 +188,7 @@ static int mlxreg_led_config(struct mlxreg_led_priv_data *priv) struct mlxreg_led_data *led_data; struct led_classdev *led_cdev; enum led_brightness brightness; + u32 regval; int i; int err; @@ -196,6 +198,23 @@ static int mlxreg_led_config(struct mlxreg_led_priv_data *priv) if (!led_data) return -ENOMEM; + if (data->capability) { + err = regmap_read(led_pdata->regmap, data->capability, + ®val); + if (err) { + dev_err(&priv->pdev->dev, "Failed to query capability register\n"); + return err; + } + if (!(regval & data->bit)) + continue; + /* + * Field "bit" can contain one capability bit in 0 byte + * and offset bit in 1-3 bytes. Clear capability bit and + * keep only offset bit. + */ + data->bit &= MLXREG_LED_CAPABILITY_CLEAR; + } + led_cdev = &led_data->led_cdev; led_data->data_parent = priv; if (strstr(data->label, "red") || -- 2.11.0