Thanks for reply, but I forgot say, that I want use only pjmedia and not pjsua. I know, there is function pjmedia_conf_adjust_rx_level and pjmedia_conf_adjust_tx_level, but I didn't use conference in my program. Thats the reason, that I want use pjmedia_aud_stream_set_cap function. Dne 9.4.2011 17:40, cg_vanderbent at mail.com napsal(a): > I use: > > pjsua_conf_adjust_tx_level(0, volume); > > and > > pjsua_conf_adjust_rx_level(0, volume); > > to set speaker and microphone volume respectively, and works fine (0.0 <= volume <= 2.0). > > Notes: > * I mute simply by setting mic volume to zero. > * A volume of 1.0 is full volume, but I go to 2.0 to have a slightly wider range. > > HTH > > Cornelis > > -----Original Message----- > From: Reklama <reklama@xxxxxxxxxxxxx> > To: pjsip at lists.pjsip.org > Sent: Sat, Apr 9, 2011 5:32 pm > Subject: Change microphone volume > > Hello, > > I have the following problem. When I change the speaker volume using the following code, everything works: > > stream = pjmedia_snd_port_get_snd_stream(sndPort); > status = pjmedia_aud_stream_set_cap(stream, PJMEDIA_AUD_DEV_CAP_OUTPUT_VOLUME_SETTING, &volumeSpeaker); > > But if I use PJMEDIA_AUD_DEV_CAP_INPUT_VOLUME_SETTING instead of the PJMEDIA_AUD_DEV_CAP_OUTPUT_VOLUME_SETTING for microphone volume control, function pjmedia_aud_stream_set_cap returns error PJMEDIA_EAUD_INVCAP (420008 - The audio capability is invalid or not supported). Is there some way to control the volume of the microphone or the microphone dis/connect from the port? > > _______________________________________________ > Visit our blog: http://blog.pjsip.org > > pjsip mailing list > pjsip at lists.pjsip.org <mailto:pjsip at lists.pjsip.org> > http://lists.pjsip.org/mailman/listinfo/pjsip_lists.pjsip.org > > > > _______________________________________________ > Visit our blog: http://blog.pjsip.org > > pjsip mailing list > pjsip at lists.pjsip.org > http://lists.pjsip.org/mailman/listinfo/pjsip_lists.pjsip.org
