Hello list, I am trying to find out if the naming convention from autovacuum does what its command line equivalent does, or at least what I think it does. QUERY: autovacuum: VACUUM ANALYZE table versus autovacuum: VACUUM ANALYZE table. I have been getting my autovacuum tuned and I have the settings where I see 2 types of queries running now and doing their jobs. I know vacuum alone will mark dead tuples ready for use again, and analyze alone will update statistics for the query planner. 1. QUERY: autovacuum: VACUUM ANALYZE table 2. QUERY: autovacuum: VACUUM table My question is do we need both? Why wouldn't QUERY: autovacuum: VACUUM ANALYZE table perform both, I always thought when issuing VACUUM ANALYZE table it would do both. Why wouldn't we just want vacuum analyze to run? Or is QUERY: autovacuum: VACUUM ANALYZE table different from the command line and it only analyzes and QUERY: autovacuum: VACUUM table only vacuums which would make sense. Thanks as always and hope this is clear. Jason Ralph This message contains confidential information and is intended only for the individual named. If you are not the named addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission. If verification is required please request a hard-copy version.
